Hardware needed for air data?

I'm a little confused as to what additional hardware I need for the air data blocks on the 540 to work.

I recently added a G5 to replace a Sandia 340 Quattro. My HSI is a King 525A.

Is it as simple as adding a Garmin GAD 13 and an OAT temperature probe?

I'm sure this has been covered previously in the forum, but a search on the obvious keywords doesn't turn up anything.

Thanks!

Rolfe

Bob,

What did you need in addition to the Shadin? Just an OAT probe and, for the fuel, a transducer?

Rolfe

I left it all up to my avionics shop.   I have a king  KI-525a HSI and the

kcs-55a  Compass system that goes with it.  I later had a G5 AI installed.  

I have a STEC 30 ALT.  All of it works seamlessly.  If the HSI ever goes

bad, I'll replace it with either a second G5, or a GI-275.

Bob

I spoke to Shadin this morning, and the ADC-200 seems like a good bet for me as I already have fuel flow with a JPI. They gave me the exact part number I need for a Bonanza along with the part number for the OAT probe. Although not a currently manufactured unit, it is still fully supported.

Thanks for all the input here...

Rolfe