Overspeed Warning

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   Just completed my 3rd flight with my newly installed DFC90 in my SR22 G1 Aspen 1000.  It’s working well but on my last flight I got an overspeed warning while cruising with an IAS of 150kts and the flaps were up.  3 voice warnings and the she went quiet.  It happened once more later in the flight at 140 KIAS and zero flaps.  Thoughts?

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
daveS Members Profile Send Private Message Find Members Posts Add to Buddy List Groupie Joined: 22 May 2019 Location: Washougal Status: Offline Points: 96	Post Options Post Reply Quote daveS Report Post Thanks(0) Quote Reply Topic: Overspeed Warning Posted: 15 Apr 2020 at 7:22pm
	Just completed my 3rd flight with my newly installed DFC90 in my SR22 G1 Aspen 1000. It’s working well but on my last flight I got an overspeed warning while cruising with an IAS of 150kts and the flaps were up. 3 voice warnings and the she went quiet. It happened once more later in the flight at 140 KIAS and zero flaps. Thoughts?
	------------ dave

AviSteve Members Profile Send Private Message Find Members Posts Add to Buddy List Admin Group Joined: 12 Feb 2018 Location: Melbourne, FL Status: Offline Points: 2252	Post Options Post Reply Quote AviSteve Report Post Thanks(0) Quote Reply Posted: 17 Apr 2020 at 9:43am
	It depends upon whether you heard "Caution Flap Overspeed" or "Caution Overspeed". If flap overspeed, it's most likely a loose wire in the flap switch circuit. You may be able to diagnose it by jiggling the switch in flight. "Caution overspeed", is based strictly on the data that we get via serial bus from the Aspen. Verify that the Aspen software is up to date for both the MAP and the IOP. Might be worth asking Aspen to see if they have had any other reports of this behavior. We did spend some time earlier this year tracking down a problem with integration of the Aspen Max units and the DFC90, which resulted in a new Aspen IOP software version. The problem we tracked down would cause a disconnect, not an overspeed, but it may be related.
	Steve Lindsley Avidyne Engineering

daveS Members Profile Send Private Message Find Members Posts Add to Buddy List Groupie Joined: 22 May 2019 Location: Washougal Status: Offline Points: 96	Post Options Post Reply Quote daveS Report Post Thanks(0) Quote Reply Posted: 17 Apr 2020 at 9:50am
	It was flap overspeed so I’ll check out the switch.
	------------ dave