Avidyne 540 & Lynx NGT 9000 w/TAS |
Post Reply |
Author | |
jdojr
Newbie Joined: 19 Oct 2019 Location: Texas Status: Offline Points: 24 |
Post Options
Thanks(0)
Posted: 12 Oct 2021 at 5:47pm |
I just installed a Lynx NGT 9000 w/TAS. I have been unable to receive traffic on the 540 screen, but receive it fine on an Aspen PFD/MFD. I am using wired connections between the Lynx and 540 & the 540 to the Aspen. I changed a few configuration settings and now my 540 shows a "TRAFFIC LOW IN YELLOW' caution allert during a ground system test of the NGT 9000. During the ground test the Aspen shows a pictorial display that emulates the Lynx. The Lynx display shows three targets. 1. A yellow target 200' below on an intercept course and two non threat aircraft 1000' above & 1000' below. My question is, is this a normal test for the 540. The pilot's guide shows the possible traffic symbols on page 4-45, but I can't tell if these symbols should show up on a ground test. Thanks, Dean
|
|
PA23
Senior Member Joined: 12 Oct 2019 Location: MMU Status: Offline Points: 317 |
Post Options
Thanks(0)
|
This is the test screen for the NGT-9000 as lifted from the pilot guide, so it seem to match what you are seeing on the IFD.
I don't have TAS which is active traffic, I only have ATAS but I would think the NGT-9000 uses the same mechanism to forward traffic to IFD. On the NGT-9000 from the configuration application MPC (downloadable directly from L3/Harris) you want to make sure the following is configured, from the Setup -> Configuration -> Modify -> I/O Options -> Misc page make sure that the RS-422 baud rate is set to 115,200 , the ADS-B Output is set to Enabled, and the RS-422 #1 Input/Output Configuration is set to Control Panel/External Display. On the IFD make sure you set the appropriate input serial interface to be "Capstone HS Trfc+Wx" |
|
jdojr
Newbie Joined: 19 Oct 2019 Location: Texas Status: Offline Points: 24 |
Post Options
Thanks(0)
|
Thanks for the reply. I now have the IFD and Lynx configured correctly and it works great! Thank you. Dean
|
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |