![]() |
Change Fuel Flow Parameter. |
Post Reply ![]() |
Author | |
Lance 33 ![]() Newbie ![]() ![]() Joined: 24 Apr 2020 Location: Australia Status: Offline Points: 7 |
![]() ![]() ![]() ![]() ![]() Posted: 25 Apr 2020 at 8:49pm |
In my Cirrus SR20 I have recently had my Engine Fuel Flow on Take off increased to 19.2 gph. So now on every take off I see a red alert because 19.2 is higher than Fuel Flow parameter set in MFD. Have been into MFD Aux page but cannot see where to adjust FF Parameter? Any suggestions please? Thanks Lance |
|
Lance
|
|
![]() |
|
AviSteve ![]() Admin Group ![]() ![]() Joined: 12 Feb 2018 Location: Melbourne, FL Status: Offline Points: 2205 |
![]() ![]() ![]() ![]() ![]() |
That value is not user configurable. During MFD development, it was imposed/specified by the manufacturer.
|
|
Steve Lindsley
Avidyne Engineering |
|
![]() |
|
Lance 33 ![]() Newbie ![]() ![]() Joined: 24 Apr 2020 Location: Australia Status: Offline Points: 7 |
![]() ![]() ![]() ![]() ![]() |
Thanks Steve.
|
|
Lance
|
|
![]() |
Post Reply ![]() |
|
Tweet
|
Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |