Avidyne Homepage
Forum Home Forum Home > Avidyne General > EX-Series Multi-Function Displays
  New Posts New Posts RSS Feed - EGT Probes
  FAQ FAQ  Forum Search   Register Register  Login Login

EGT Probes

 Post Reply Post Reply
Author
Message
jsamford View Drop Down
Newbie
Newbie
Avatar

Joined: 30 Jan 2013
Location: Savannah, GA
Status: Offline
Points: 11
Post Options Post Options   Thanks (0) Thanks(0)   Quote jsamford Quote  Post ReplyReply Direct Link To This Post Topic: EGT Probes
    Posted: 30 Apr 2013 at 8:49am
I recently had a failure of the #4 EGT probe and had a mechanic replace it. After about 30 hours of flying, the same probe failed again. After again replacing it, I had a third failure after about three hours of flying. Finally, a few minutes later, the entire EGT display on the MFD stopped working.

A little online research showed part of the problem. I found Piper "Service Spares Letter 428A" where new EGT thermocouplers were made available for my Piper 6X. My mechanic had no idea these were not generic  "Type K" probes. While we need to now replace the #4 probe with the correct Piper part, I am curious what would cause the complete failure of all EGT readouts. Would this have been caused by using the wrong EGT probe on #4 or is this an unrelated wiring or MFD issue? And should this be handled by an avionics shop or mechanic?
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 12.01
Copyright ©2001-2018 Web Wiz Ltd.

This page was generated in 0.087 seconds.