![]() |
Prereq to activate Traffic thumbnail datablock? |
Post Reply ![]() |
Author | |
chflyer ![]() Senior Member ![]() ![]() Joined: 24 Jan 2013 Location: LSZK Status: Offline Points: 1022 |
![]() ![]() ![]() ![]() ![]() Posted: 08 Jan 2024 at 5:40pm |
I would like to add a traffic thumbnail datablock, but it is greyed out in the SETUP/Datablocks section.
Does anyone know what prerequisites need to be filled to make that datablock selectable? I don‘t see anything specific in the PG. IFD is on 10.3.1.2.
|
|
Vince
|
|
![]() |
|
AviSteve ![]() Admin Group ![]() ![]() Joined: 12 Feb 2018 Location: Melbourne, FL Status: Offline Points: 2168 |
![]() ![]() ![]() ![]() ![]() |
It's most likely because there's not enough room to display the traffic thumbnail. Clear some datablocks where you're trying to put it (e.g. on the left side) and I'll bet you see the traffic thumbnail selection is no longer greyed out.
|
|
Steve Lindsley
Avidyne Engineering |
|
![]() |
|
chflyer ![]() Senior Member ![]() ![]() Joined: 24 Jan 2013 Location: LSZK Status: Offline Points: 1022 |
![]() ![]() ![]() ![]() ![]() |
Thanks Steve. I was trying to put it on the right side, and this should work since it‘s shown there as an example in the PG. I‘ll play a bit and put it higher on the right side or on the left side.
|
|
Vince
|
|
![]() |
|
chflyer ![]() Senior Member ![]() ![]() Joined: 24 Jan 2013 Location: LSZK Status: Offline Points: 1022 |
![]() ![]() ![]() ![]() ![]() |
That worked, both for the traffic thumbnail and wind vector. I seem to have filled up most of the space on the right side and adding a larger datablock no longer fit.
|
|
Vince
|
|
![]() |
Post Reply ![]() |
|
Tweet
|
Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |