AMX240 Audio Panel - How do pilots use the MON function

Print Page | Close Window

How do pilots use the MON function

Printed From: Avidyne
Category: Avidyne General
Forum Name: AMX240 Audio Panel
Forum Description: Topics on the Avidyne AMX240 Audio Panel
URL: http://forums.avidyne.com/forum_posts.asp?TID=2421
Printed Date: 23 Nov 2024 at 9:24pm
Software Version: Web Wiz Forums 12.01 - http://www.webwizforums.com

Topic: How do pilots use the MON function

Posted By: rpierz
Subject: How do pilots use the MON function
Date Posted: 21 Oct 2022 at 7:07am

I am going to upgrade to the AMX 240 when I receive/install Vantage upgrade. I was wondering how pilots use the MON function. I would expect that I would use it to monitor ATIS prior to switching to approach, and perhaps monitor guard.

1. Any other tips on how to use this function?

2. Does MON automatically mute when a transmission is received on the primary frequency. I know it is supposed to but some (older) forum posts said this didn’t work

Thanks

-------------
Rick Pierzchajlo

Replies:

Posted By: Gring
Date Posted: 21 Oct 2022 at 9:13am

I have the AMX240 and I have dual IFD540s which have comm radios (obviously). I use my #1 for air to ground frequencies (antenna on the bottom of the aircraft), and I use my #2 for ground to ground frequencies (antenna on the top of the aircraft). I use the MON feature during the approach phase to monitor the UNICOM frequency so I understand the traffic. Other than that, I might use it temporarily here and there. I generally put 121.5 in my #2 standby frequency and use MON to monitor it, but lately it has so much garbage on it, I end up turning it off.

Hope this helps.