Avidyne Homepage
Forum Home Forum Home > Avidyne General > IFD 5 Series & IFD 4 Series Touch Screen GPS/NAV/COM
  New Posts New Posts RSS Feed - IFD440 and Dynon XPNDR Settings
  FAQ FAQ  Forum Search   Register Register  Login Login

IFD440 and Dynon XPNDR Settings

 Post Reply Post Reply
Author
Message
timfwalsh01 View Drop Down
Newbie
Newbie


Joined: 09 Jan 2017
Location: Wash DC
Status: Offline
Points: 16
Post Options Post Options   Thanks (0) Thanks(0)   Quote timfwalsh01 Quote  Post ReplyReply Direct Link To This Post Topic: IFD440 and Dynon XPNDR Settings
    Posted: 24 Mar 2022 at 1:29pm
Folks,


In my HDX Skyview and SV-XPNDR-261 panel, I just replaced my GNS-430W with a new IFD440.


The plane is outside the hanagar and locked on to a waypoint. ARINC data is showing up on HSI.


In the XPNDR-261 SETUP page, I did set it to GPS DATA "AVIDYNE IFD540/IFD44" GPS DATA OFFLINE


The real question - what is the correct RS232 Config Setting?  Previously the GNS-430W was set to "ADSB OUT +"


I called AVIDYNE and he was not sure. they are several options.


Assistance is greatly appreicated!!  Thanks, Tim

Tim Walsh
Back to Top
timfwalsh01 View Drop Down
Newbie
Newbie


Joined: 09 Jan 2017
Location: Wash DC
Status: Offline
Points: 16
Post Options Post Options   Thanks (0) Thanks(0)   Quote timfwalsh01 Quote  Post ReplyReply Direct Link To This Post Posted: 26 Mar 2022 at 10:35am
UPDATE - I spoke to a Dynon Tech Rep and the correct IFD440 replacement for "ADSB OUT +" is now "ADS-B (Avi)"

Some one on the Dyon forum mentioned that the IFD550 still has "ADSB OUT+"

I tested and now the Transponder works fine/legal.  

Hope this helps.  Tim


Edited by timfwalsh01 - 26 Mar 2022 at 10:37am
Tim Walsh
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 12.01
Copyright ©2001-2018 Web Wiz Ltd.

This page was generated in 0.082 seconds.