![]() |
IFD Dimming after Database Update |
Post Reply ![]() |
Author | |
gremlin ![]() Groupie ![]() ![]() Joined: 23 Jun 2021 Location: Pacific NorthWe Status: Offline Points: 48 |
![]() ![]() ![]() ![]() ![]() Posted: 03 Sep 2024 at 2:08pm |
Since my IFD440's were updated to 10.3.1.2 I have a persistent and annoying problem
after I update the Nav and Obstacle databases on any cycle the IFD's reboot and they're both Dim, instead of being full brightness. I have to do the dance to "Download logs" and reboot into maitenance mode then go to the dimming screen and then they pop to full brightness and work from then out for every reboot until I do the next update. Every single time I have to do this dance. To begin with there was a PIN on the settings so I ran the reset procedure and now the values shown in the config screen is correct, and all I have to do is go to that page, I don't have to change anything then it all just works. Any ideas, it's not unworkable but it's an annoying extra step every DB update.
|
|
![]() |
|
PA23 ![]() Senior Member ![]() Joined: 12 Oct 2019 Location: MMU Status: Offline Points: 317 |
![]() ![]() ![]() ![]() ![]() |
I'd suggest starting with setting the lighting page to a known good configuration just in case something is FUBAR there. Below is what I'm using in my IFD440 which I got it from somebody on this forum and tweaked it slightly for my tastes. ![]() |
|
![]() |
|
gremlin ![]() Groupie ![]() ![]() Joined: 23 Jun 2021 Location: Pacific NorthWe Status: Offline Points: 48 |
![]() ![]() ![]() ![]() ![]() |
@PA23 appreciate that and will double check, I actually use DIMBUS not photocell on mine, and as I said above it works entirely, until a DB update, then it fails, and simply swapping to that page it will all work again until the next DB update, I don't actually have to change anything.
|
|
![]() |
|
jimmyz80 ![]() Groupie ![]() ![]() Joined: 24 Jul 2016 Location: Folsom, CA Status: Offline Points: 99 |
![]() ![]() ![]() ![]() ![]() |
Just chiming in to say to say that I have this exact same problem. Dimming works as configured/expected until you do a database update. Then it breaks until you just go back into maintenance mode and look at the lighting page. Then it fixes everything back up again until the next database update. I made a video today of me reproducing the issue and will be opening a support case.
|
|
2006 Cirrus SR22 - IFD540 IFD440 DFC90 AXP322 MLB100
|
|
![]() |
|
AviSteve ![]() Admin Group ![]() ![]() Joined: 12 Feb 2018 Location: Melbourne, FL Status: Offline Points: 2227 |
![]() ![]() ![]() ![]() ![]() |
I guess I'll wait to see the video, but that's certainly an odd one. I load databases all the time and haven't noticed such behavior. Do you both have the same database coverage?
|
|
Steve Lindsley
Avidyne Engineering |
|
![]() |
|
jimmyz80 ![]() Groupie ![]() ![]() Joined: 24 Jul 2016 Location: Folsom, CA Status: Offline Points: 99 |
![]() ![]() ![]() ![]() ![]() |
Check out case #PS00134823 and I've included a google drive link with the video. I just double checked my coverage and it's listed as North America.
|
|
2006 Cirrus SR22 - IFD540 IFD440 DFC90 AXP322 MLB100
|
|
![]() |
|
gremlin ![]() Groupie ![]() ![]() Joined: 23 Jun 2021 Location: Pacific NorthWe Status: Offline Points: 48 |
![]() ![]() ![]() ![]() ![]() |
Same North America, happens every single time, there's a discussion on the Cirrus forums and three of us currently have exactly this behaviour. I have not seen the video from Jimmz80 but his repro steps are the same as mine. And it happens every single time to both IFD's.
I even tried reformatting the key I used for the IFD's in case it had a left over config file that was tripping it up, same result. |
|
![]() |
|
gremlin ![]() Groupie ![]() ![]() Joined: 23 Jun 2021 Location: Pacific NorthWe Status: Offline Points: 48 |
![]() ![]() ![]() ![]() ![]() |
@AViSteve So one thing that came up on the COPA forums the units that are doing this are possibly all using "DimBus" and not "Photocell" for the dimmer, what's your demo unit using?
|
|
![]() |
|
ansond ![]() Senior Member ![]() Joined: 12 Nov 2009 Location: Austin, Texas Status: Offline Points: 149 |
![]() ![]() ![]() ![]() ![]() |
I have also seen this behavior... after the DB update, I would go back into the configuration page to the lighting section and, when I landed on that section, the screen would light back up... its almost like landing on that section "resets" the configuration somewhere within the IFD... flaky.
I ended up switching to "photocell" vs. the "dimming bus" and that seems to have helped a bit. Doug N208LG |
|
![]() |
|
AviSteve ![]() Admin Group ![]() ![]() Joined: 12 Feb 2018 Location: Melbourne, FL Status: Offline Points: 2227 |
![]() ![]() ![]() ![]() ![]() |
I usually keep it on manual, so I'll have to give it a try using the dimming bus.
Edited by AviSteve - 09 Sep 2024 at 9:12am |
|
Steve Lindsley
Avidyne Engineering |
|
![]() |
|
gremlin ![]() Groupie ![]() ![]() Joined: 23 Jun 2021 Location: Pacific NorthWe Status: Offline Points: 48 |
![]() ![]() ![]() ![]() ![]() |
That would be great to test, it does seem to be common, and I much prefer to have control over it and have it match the other instruments as it has since I bought them.
|
|
![]() |
|
jimmyz80 ![]() Groupie ![]() ![]() Joined: 24 Jul 2016 Location: Folsom, CA Status: Offline Points: 99 |
![]() ![]() ![]() ![]() ![]() |
Same here, since everything in the Cirrus is controlled from the dimming bus. It's nice to have the IFDs follow along as well, vs. having them do their own thing based on a photocell.
|
|
2006 Cirrus SR22 - IFD540 IFD440 DFC90 AXP322 MLB100
|
|
![]() |
|
gremlin ![]() Groupie ![]() ![]() Joined: 23 Jun 2021 Location: Pacific NorthWe Status: Offline Points: 48 |
![]() ![]() ![]() ![]() ![]() |
I noticed when I had my recent update I only had to go to the configurations page for it to correct itself.
|
|
![]() |
|
gremlin ![]() Groupie ![]() ![]() Joined: 23 Jun 2021 Location: Pacific NorthWe Status: Offline Points: 48 |
![]() ![]() ![]() ![]() ![]() |
@AviSteve so have you managed to reproduce this in house? It's been several weeks and would at least like to know they have an in house repro of this issue that several of us seem to have with every up date.
|
|
![]() |
Post Reply ![]() |
|
Tweet
|
Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |